Reflow soldering workshop
From Whitespace (Hackerspace Gent)
(Difference between revisions)
(→Final profile) |
|||
| Line 38: | Line 38: | ||
[[File:wetrun3.png]] | [[File:wetrun3.png]] | ||
| + | Comparing this profile to the 'ideal' solder profile, the main difference is that we do not dwell on the 'pre-heat' phase (ie. 150-200°C). This is because we could not get the temperature to rise fast enough, so we were forced to stick to a steady, slow ramp. | ||
= Results = | = Results = | ||
Revision as of 18:52, 13 December 2011
Note: this article is about a passed event.
| Reflow soldering workshop |
|---|
|
| From 2011/12/11 14:00:00 to 2011/12/11 18:00:00 |
| Presenters ({{#arraydefine:p|johannes}}{{#arraysize:p}}warning.png"{{#arraysize:p}}" is not a number.): |
| johannes |
| Where: |
| Whitespace
Blekerijstraat 75, Gent, Belgium Loading map...
Costs 0 |
|
Reflow soldering workshop not teaching, but testing this technique
tools available
- Aoyue hot-air station
- pizza oven + sparkfun reflow controller
- solder paste
- test circuit boards
Solder profiles and background info
Contents |
Initial heater test
Programs used
Final program:
0 15s 40°C 1 150s 150°C 2 90s 215°C 3 90s 265°C 4 40s 265°C 5 120s 40°C
Final profile
Comparing this profile to the 'ideal' solder profile, the main difference is that we do not dwell on the 'pre-heat' phase (ie. 150-200°C). This is because we could not get the temperature to rise fast enough, so we were forced to stick to a steady, slow ramp.
Results
Subpages
Page "Reflow soldering workshop" has no subpages to list.
Facts about Reflow soldering workshopRDF feed
| Has cost | 0 + |
| Has end date | 11 December 2011 18:00:00 + |
| Has event type | Workshop + |
| Has location | Whitespace + |
| Has presenter | Johannes + |
| Has presenter amount | |
| Has start date | 11 December 2011 14:00:00 + |
