Electronics workshop 1
From Whitespace (Hackerspace Gent)
(Difference between revisions)
| Line 4: | Line 4: | ||
|End date=2012/12/06 23:59:59 | |End date=2012/12/06 23:59:59 | ||
|Location=Whitespace | |Location=Whitespace | ||
| − | |Short description= | + | |Short description=Introducing technology available to the enthousiast. PCB design & assembly |
| − | PCB design & assembly | + | |
|Cost=0 | |Cost=0 | ||
|Logo=WhitespaceLogo.gif | |Logo=WhitespaceLogo.gif | ||
Latest revision as of 20:20, 18 November 2012
Note: this article is about a passed event.
| Electronics workshop 1 |
|---|
|
| From 2012/12/06 20:30 to 2012/12/06 23:59:59
|
| Where: |
| Whitespace
Blekerijstraat 75, Gent, Belgium Loading map...
Costs 0 |
|
«Introducing technology available to the enthousiast. PCB design & assembly»
First meeting to find out what people would like to learn and who is willing to teach us. For example:
- working with SMD components. it opened my eyes when Johannes showed up with a small cheap booklet that holds +-4000 SMD resistors and capacitators. it's not impossible for the amateur, and a big improvement
- Arduino/Raspberry Pi interfaces. SPI, one wire protocol,...
- where to buy parts? Gotron is expensive, Farnell is cool, Asian Ebay is dirt cheap
- perfboard assembly: tips, tricks, best practices,.... I know there's a lot to learn, even with a Bachelor degree in electronics I've made a lot of shitty prototype boards- is there a reasonable way to etch a PCB at home? it does not have to be high-tech multi-layer, but would it be an improvement over the prototype boards?
Subpages
Page "Electronics workshop 1" has no subpages to list.
Facts about Electronics workshop 1RDF feed
| Has cost | 0 + |
| Has description | Introducing technology available to the enthousiast. PCB design & assembly |
| Has end date | 6 December 2012 23:59:59 + |
| Has event type | Workshop + |
| Has location | Whitespace + |
| Has start date | 6 December 2012 20:30:00 + |
